Telescopic Scooter & Powerchair Ramps

• Made from anodized aluminium, these telescopic ramps can carry up to 551Lbs (250kg) per set.
• They have a non-slip surface on the ramp and also on the contact surfaces at the top and bottom, to prevent sliding whilst in use.

**Important Information**

• Please note these are channel ramps therefore have two side walls.
• The inner side wall may catch the underneath of your scooter, this will result in it being grounded which will lift the wheels of the ground.
• You MUST check the ground clearance of the scooter especially around the rear axle & differential & make sure this is higher than the side wall measurement.
• If you are in any doubt please phone: 0870 199 8246 with the make a model of your scooter.

1.5m (5 Foot)